Anti rust measures for hydraulic cylinder of hydraulic press
When the hydraulic press is in use, if the environment is relatively wet, the hydraulic cylinder may be corroded and rusted after long-term use, which will affect the normal and stable operation of the equipment. What measures should be taken to prevent rust during use?
One of the effective rust prevention measures for hydraulic cylinder of hydraulic press is plating filling. After metal plating, it has good chemical stability, can resist the erosion of humid air and other gases, and can resist the corrosion of alkali, nitric acid, organic acid, etc. At the same time, after lead plating, the hardness increases and the friction coefficient decreases, so the wear resistance is greatly enhanced. However, it can not resist the corrosion of hydrochloric acid, hot sulfuric acid, etc.
As a general antirust or only for wear resistance, the lead plating layer can only be 0.02-0.03mm. For the hydraulic cylinder working in wind, rain and humid air, the plating layer shall be more than 0.05mm, or it can be plated. For hydraulic cylinders working in seawater, stainless steel and other materials shall be used as much as possible. In addition, stainless steel or Mingjin steel shall also be considered for bolts and nuts of hydraulic cylinder.
The surface of the piston rod of the hydraulic cylinder of the hydraulic press is hardened. The external working conditions of some hydraulic cylinders are very bad. For example, the piston rod of the hydraulic cylinder of the scraper often collides with sand and stone, and the piston rod or calibration plug of the hydraulic cylinder of the press should directly press the workpiece. Therefore, the surface hardness of the piston rod must be improved. The main method is high-frequency foreign fire, the depth is 1-3mm, and the hardness HR ℃ is 40-50.
The hydraulic cylinder is an important part of the hydraulic press, so it must be maintained and repaired regularly to ensure its normal use.