Raw material rubber cutter is an indispensable equipment in some light industry. In the traditional concept, the cutting machine is a machine that cuts and processes materials by pressurizing the cutter die with the help of the force of machine movement. Some changes have taken place in modern cutting machines, and advanced technologies such as high-pressure water beam and ultrasonic have been used in leather punching and cutting technology, but these equipment are still summarized in cutting machine equipment.  
 
According to the structure of rubber cutting frame, it can be divided into vertical rubber cutting machine and horizontal rubber cutting machine; According to the cold and heat of the cutter, it can be divided into cold cutter and hot cutter. According to the number of pieces of the cutter, it can be divided into single cutter and multi cutter. According to the working principle of the cutter, it can be divided into hydraulic cutter, pneumatic cutter and electric drive cutter.  
The horizontal hydraulic rubber cutter is equipped with a star ten edge cutter. The unheated rubber block can be cut into ten wedge-shaped blocks by oil pressure, and sent to the continuous heating chamber for heating through the knife gap for plastic refining. Safe operation, large output, and create conditions for the automation and continuity of production process.  
In addition, there are hydraulic drive, motor drive and compressed air drive vertical rubber cutting machines, as well as styrene butadiene rubber cutting machines that cut the film into thin strips in advance for thermoplastic refining. The glue cutter is mainly composed of glue cutter, frame, working oil cylinder, base, auxiliary workbench, hydraulic system, electrical system, etc. nylon backing plate is installed on the base under the glue cutter to protect the blade of the glue cutter. When cutting raw rubber, manually place the rubber under the rubber cutter, and then press the start button, the rubber cutter will fall along the slide on the frame driven by the piston rod to cut the rubber. Two limit switches are installed on the frame to control the directional valve to change the movement direction of the rubber cutter. At the same time, it can also protect the cylinder head of the piston cylinder.